To join the top of my chair I had to cut a triangular piece of pine to the correct angles so that they would fit nicely with the curved frame underneath, to clamp it on tightly I had to screw the frame but the holes will be filled with small pieces of the darker wood. When this had fully dried I then used the Radius Sanding Jig the round off the top so that a darker piece of wood could slot in. When all these pieces were dry I used the detail sander to shape the pieces to my desired shape.
 |
| CLAMPING THE UNDERSIDE PIECE |
 |
| TOP PIECE HALFWAY SANDED DOWN (FRONT) |
 |
| BOTTOM PIECE HALFWAY SANDED DOWN (FRONT) |
 |
| TOP PIECE HALFWAY SANDED DOWN (BACK) |
 |
| FULLY SHAPED READY TO SAND TO P150 GRAIN |
No comments:
Post a Comment